Banding in my scan with SilverFast 8

Banding in my scan with SilverFast 8

If you have a stripes in your image in regular and broad fashion with no variation in colors, please try the following:

1) Start SilverFast only up to its welcome screen
2) Click on "Service Dialog" on the lower left corner
3) Click on the "Reset SN and quit" button on the right
4) Restart SilverFast, go to -> Start in the lower right, and reenter the serial and first name, last name combination when asked for it
5) Click Unlock

6) Click on Start and go back into the program.

 

This should fix the stripes issues for good.

    • Related Articles

    • Color Cast appears on final scan when scanning negatives

      You are scanning negatives and compared to the preview scan, the image finally saved differs in color and or brightness? When scanning or processing negatives, the "NegaFix" filter gets different input data depending on the scanning resolution and ...

    • My scan preview brightness is correct but the final scan saved image is very dark. What is causing this?

      If your final scan looks very dark when viewing in any third-party image editor, this is most likely attributed to the raw scan feature in SilverFast. Why is my final scan dark? When using the HDRi RAW mode, the software captures the maximum amount ...

    • Which Preset and Scan Resolution do I need?

      SilverFast offers a preset and a resolution slider to control the input and output resolution of your images. If you plan to blow up an image, you need a resolution large enough to allow for the necessary scaling of the original image. You can set ...

    • How can I scan several images at the same time?

      With a flatbed scanner you can scan image by image or a selection of images in a batch. SilverFast is based on the use of frames. Each frame represents a single image and is going to be stored in a separate file. There is one active frame, which is ...

    • Reset SilverFast 8

      To do this please follow these steps: - close SilverFast if it is running and re-launch it - enter the "Service Dialog" in the initial Welcome screen - check the box "Remove scanner Preferences" and then - click "Software Reset" - Quit SilverFast and ...